Control sealing from the connector interface through the complete cable assembly.
Marine instruments and submerged sensors require more than a nominal IP rating. Depth, immersion duration, pressure cycles, salt exposure, cable jacket and rear sealing must be reviewed as a complete connection system.
What the system must connect
- W Series connectors for submerged sensors and underwater instruments.
- K and F Series sealed push-pull interfaces for deck and splash-zone equipment.
- Sealed panel receptacles with controlled rear-side termination.
- Cable assemblies designed around pressure, water blocking and strain relief.
- Protective caps and service procedures for unmated connectors.
Define before release
- Define depth, pressure, immersion duration and mating condition.
- Review salt exposure, temperature and material compatibility.
- Specify cable jacket, diameter, water blocking and bend radius.
- Validate sealing and electrical tests on the approved assembly.
Compatible LMConn products
Recommended product directions
These products are practical starting points for this application. Final pin count, coding, gender, cable and electrical ratings must be confirmed on the approved drawing.
